ShareThis!!!

Solving the Echo1 M240 Bravo Trigger Switch Contact Issue

As some of you Echo1 M240 Bravo owners may already know, there is a bit of a design flaw with the position of the trigger switch inside the gun.

The wires that connect to the switch's contact plates stick out a bit too in the back, making it difficult to install the stock after inserting a battery or putting the gun away for storage or transportation in a case.  

When installing the stock onto the back of the gun's receiver, the bottom portion of the stock would catch on the wires attached to the thin, metal contact plates of the trigger switch, causing the plates to bend back & forth, which weakens the metal each time it is bent.  Eventually, I broke one of the plates off and had to spring for a whole new trigger switch.  
So I installed the new trigger switch, but the problem was not resolved, so I knew it was only a matter of time before I would be replacing it again if I didn't figure something out.  
First, I thought about bending the wire terminals into more of a 90-degree angle to try and get them out of the way, but the jackets used by the manufacturer were a bit too thick to allow them to bend completely out of the way and I wasn't sure that replacing them with smaller shrink tubing was going to do a whole lot more good either.
 So I took a more drastic route that worked marvelously.
I cut that SOB.  I cut it hard...with a Dremel.

 I noticed, upon initial examination of the stock that there was quite a bit of unnecessary material at the exact point where the stock was snagging on the wire terminals.  I, therefore, removed most of the material, leaving enough to keep the stock's spring-loaded latch in place.  When I tried installing the stock with the excess material removed, it went on like butter, as they say.  Threat neutralized.

I will add that the material I removed is part of a metal adapter on the stock, so while I suppose you could use a hand file set if you didn't have a rotary tool like a Dremel, it will likely take you quite a bit longer to complete this task.  Fair warning.
AIRSOFT JOB OPPORTUNITY ALERT: Pyramyd Air is looking for enthusiastic individuals who have a good knowledge of Airsoft products to help them assist their customers while shopping at www.PyramydAir.com.  You'll get paid to talk about Airsoft stuff AND you can do it from the comforts of your own home!  Click the following link to register with Needle and get all the details.  https://pincushion.needle.com/needlers/register/pyramydair 
Elite Force Airsoft BBs, Airsoft ammo, What's in your mag?, airsoft bbs for sale, airsoft ammo for sale, bulk airsoft ammo, cheap airsoft bbs, cheap airsoft ammo, precision airsoft bbs, precision airsoft ammo, Pyramyd Air, Umarex, Pyramyd Airsoft Blog, Tom Harris Media, Tominator,
Elite Force Airsoft BBs on Sale!
Pyramyd Air
Pyramyd Airsoft Facebook Page, Big Shot of the Week, Win $50, Win Fifty Bucks, Pyramyd Airsoft Blog, Pyramyd Airsoft Youtube Channel, Tom Harris Media, Tominator, Airsoft Guns,
If you're done browsing here on the Pyramyd Airsoft Blog, would you mind sharing this blog with friends on Facebook? Perhaps even on your favorite Airsoft forum?

Speaking of Facebook, check out our new Facebook page for Pyramyd Airsoft and get in on a chance EVERY WEEK to WIN FIFTY BUCKS ($50) or check out our Pyramyd Airsoft YouTube Channel for a ton of great Airsoft video reviews, unboxing videos and actual Airsoft gun performance tests.
Pyramyd Airsoft Facebook Page, Pyramyd Airsoft Blog, Pyramyd Airsoft Youtube Channel, Tom Harris Media, Tominator, Airsoft Guns,
Pyramyd Airsoft Youtube Channel, Pyramyd Airsoft Facebook Page, Pyramyd Airsoft Blog, Tom Harris Media, Tominator, Airsoft Guns,

Recent Stuff from the Tominator